Crispeed Tuned Turbo 1st Gen
#1
1985 RX-7 GSL-SE
13BRE "Cosmo" Two rotor
93 Pump Fuel / Low Boost Setting (14 PSI)
Haltech E6K / 63-1 Turbo
Ford 8.8 Rear End (much heavier, with more drivetrain loss)
Nasty, Hot Conditions - 100 degrees+
408 RWHP at 14 PSI
Crispeed Tuned.
[attachment=33149:attachment]
Don't go by the A/F numbers on the Sheet, the Dyno's wideband was off by .75 or more +/-.
We were getting bad ignition readings over 14PSI, so we couldn't run anymore boost. Might have a bad CAS. Will look into it this week.
The car did 340 at 9 PSI (Wastegate spring) and 408 at 14PSI. Looking forward to 17 and 19 PSI on pump gas. Then go for broke on Race Fuel.
I am verrrrry happy with the Turbo. The boost comes on nice and quick,
with no lag. Pulls like a freight train. The drag radials are no match for traction.
BIIIIG Difference in drivability over the Holley Blow-Through setup I previously had. Not to mention, more power under the curve.
I am in love all over again.
Thanks Cris.
13BRE "Cosmo" Two rotor
93 Pump Fuel / Low Boost Setting (14 PSI)
Haltech E6K / 63-1 Turbo
Ford 8.8 Rear End (much heavier, with more drivetrain loss)
Nasty, Hot Conditions - 100 degrees+
408 RWHP at 14 PSI
Crispeed Tuned.
[attachment=33149:attachment]
Don't go by the A/F numbers on the Sheet, the Dyno's wideband was off by .75 or more +/-.
We were getting bad ignition readings over 14PSI, so we couldn't run anymore boost. Might have a bad CAS. Will look into it this week.
The car did 340 at 9 PSI (Wastegate spring) and 408 at 14PSI. Looking forward to 17 and 19 PSI on pump gas. Then go for broke on Race Fuel.
I am verrrrry happy with the Turbo. The boost comes on nice and quick,
with no lag. Pulls like a freight train. The drag radials are no match for traction.
BIIIIG Difference in drivability over the Holley Blow-Through setup I previously had. Not to mention, more power under the curve.
I am in love all over again.
Thanks Cris.
#4
Thread
Thread Starter
Forum
Replies
Last Post
rx2tones
RX-7 & RX-8 Parts For Sale & Wanted
2
06-07-2006 07:02 AM
SPEED_NYC
Rotary Engine Building, Porting & Swaps
9
02-13-2003 05:29 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)