My priorities have changed recently and this project car needs to go. I am only going to entertain serious offers. I don't want to list everthing as it would take me all day. I will discuss with you over the phone or via email all the details but I will give you the basics here. I have over 20k in reciepts into this thing, and it needs very little to be finished.

-1987 Turbo II

-0 miles on rebuilt 1/2 bridged 13B-RE Cosmo motor

-KGParts rails w/ RC 750 primaries, KG 1680 secondaries, Aeromotive FPR

-Garret T04R on Greddy manifold, ceramic coated manifold and hotside, Turbosmart w/g

-Precision Turbo water-air I/C custom fabbed to front of motor, greddy elbow on FD T/B

-all supporting items for I/C setup (heat exch., pump, cell)

-Surgetank fuel setup w/walbro in tank, Aeromotive A1000 feed pump

-Higgi short shifter on rebuilt trans

-Haltech E6X with terminated harness

-brand new FD alternator

-Interior is 9/10

-exterior is 8/10-recent paint job

-MB Motoring 17s with brand new tires (maybe 100 miles on them)





Hopefully this is enough info to grab your attention. I am leaving out tons of info, I have pages of reciepts. If I can't sell this car as a whole it will sadly be parted out.



As it sits it is not running. It needs very little to be finished.



The car is in Albuquerque, NM. I am asking $10,000 for everything. I will entertain serious offers as I do not want to part this car out. If you would like to go into serious detail and are serious about buying, PM me and I will give you my phone number. I am busy and do not have time for strokers, so please be considerate and only contact me if you are serious.



Thank you.

-Sean

 

Can you post some pic's? If it has new paint why do you give it a 8 out of 10 rating? What dose it need to run??

 

I'll post some pics tonight. I give the body an 8/10 because there are a couple of scratches in the new paint job that are down to the primer, and the front bumper cover needs to be painted the same colo as the car.



The radiator needs to be fabbed in, it was custom made to fit between the frame rails but has no mounting brackets on it. After that it is all small stuff: vacuum lines need to be run, fuel lines need to be plumbed, I/C needs to be plumbed, and some parts of the interior need to be put back together.



If you go into my public profile and look at some of my past posts there are some pics.

 

"Tonight" would have been 8-23, but it is now 8-28 and no pics...



bah!

 

camera took a crap, sorry. Like I said if you'd like you can look through some of my past topics and see some of the progress pics. Battery for the camera should be here tomorrow, and I'll get some current ones up.