1988 rx-7 TII 10th anniversary FS
#1
doesn't run and is really only for restoration or parts/wont pass inspection the way it is. heres what is wrong with the car
Car has a bent subframe and the engine wont start due to oil/gas collected at the bottom of the rotor housing and needs to be cleaned out after the turbo went(already replaced)
Engine: has a reman 13bt motor with about 12k on it,full fujitsubo exhaust + 3 inch down pipe, Hks ground system, Rc enginering 550cc injectors, performance radiator, new alternator, Greddy type s blow off valve, K&N performance filter.
transmission: Rebuilt tranny about 12k miles ago with all shifter bushings replaced, Cs short throw shifter
Suspension etc: Front strut tower bar, KYB AGX adjustable struts front and rear, Racing beat sway bars,eibach springs,x-drilled slotted zinc plated brembo rotors all around
Exterior/interior: KSP headlight duct feed right into k&n, White faced/carbon fiber indiglo cluster with fade control,SPI boost gauge mounted on a Pillar, and black arc rims 17s.
Car looks pretty good Please e-mail me for pictures at crokett88@aol.com
The price is $2,500.00 with an apexi safcII and apexi Acvr with all to hook them up to the car, or $2,000.00 without them.
The car is located in Weymouth Ma. i will do what i can to help with transportation.
Thanks.
Dave
Car has a bent subframe and the engine wont start due to oil/gas collected at the bottom of the rotor housing and needs to be cleaned out after the turbo went(already replaced)
Engine: has a reman 13bt motor with about 12k on it,full fujitsubo exhaust + 3 inch down pipe, Hks ground system, Rc enginering 550cc injectors, performance radiator, new alternator, Greddy type s blow off valve, K&N performance filter.
transmission: Rebuilt tranny about 12k miles ago with all shifter bushings replaced, Cs short throw shifter
Suspension etc: Front strut tower bar, KYB AGX adjustable struts front and rear, Racing beat sway bars,eibach springs,x-drilled slotted zinc plated brembo rotors all around
Exterior/interior: KSP headlight duct feed right into k&n, White faced/carbon fiber indiglo cluster with fade control,SPI boost gauge mounted on a Pillar, and black arc rims 17s.
Car looks pretty good Please e-mail me for pictures at crokett88@aol.com
The price is $2,500.00 with an apexi safcII and apexi Acvr with all to hook them up to the car, or $2,000.00 without them.
The car is located in Weymouth Ma. i will do what i can to help with transportation.
Thanks.
Dave
#3
maybe get some pictures going, the bent subframe and fact the motor does not run right hurts the sale, but your listing of parts sounds good and gives the car some value, at least for parts anyhow.
Thread
Thread Starter
Forum
Replies
Last Post
salter00
RX-7 & RX-8 For Sale
2
05-08-2013 06:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)