i have for sale a rebuilt stage 2 port/polish has 1,100 miles

parting out due to rear end..this engine was built with all quality parts

with jdm low mileage rotor housings...this engine comes as a long block and is fully powder coated blue/silver it included the fallowing



rotary aviation apex seals

93+ solid corner seals

93+ corner seal springs

atkins rebuild kit

s5 jdm rotor housings

stage 2 port/polish from dave at rotary heads .com

ported polished throttle body also by dave at rotaryheads

every seal replaced

all new gaskets

all emissions removed

andonized blue block off plates

rebuilt 550cc primary's

greddy 720cc secondary's

all intake manifolds

dual belt alt pulley

s5 turbo

f1 racing clutch(1,100 miles also)

turbo tranny if needed..

3"turbo inlet duct

wiring harness and ecu (rtek 1.7 at an extra cost)





all of the above for $2,500 this is damn near a racing engine drop in before rebuild and port i ran 14.02 at 98...engine was also broken in properly= no boost and rpm under 5k..

 

bump

 

>bump

 

bump

 

anyone,,,,,???

 

i might have a guy interested in this motor. hes looking for a t2 long block to put in a 1st gen rex. how much HP is this motor putting down?