Hey guys, I'm a member over at rx7club.com, have been there for 7 years with a lot of posts. Never posted in here but you can verify me over there.

Just went single, and selling the following:

M2 downpipe - $300 plus shipping
http://imageshack.us/a/img197/8720/20130401173503.jpg

SMIC w/ ducting and greddy bov - $400 plus shipping
http://imageshack.us/a/img805/8964/20130401173328.jpg

http://imageshack.us/a/img843/7162/20130401173108.jpg

http://imageshack.us/a/img827/446/20130401173023.jpg


Also have an engine just pulled out to swap in my streetported single setup. Engine runs FLAWLESS. No smoke, no hardstarts, omp pump intact. Its a mazda reman w 70k miles. car has been maintained at 10-12psi stock twins since I'v owned it for 7 years and pulls 19inches of vaccum at idle. My new streetport doesn't crank as quickly.

Looking for 2,000 dollars or best offer for full long block with turbos, tranny no grinds, act/streetstrip/flywheel w/ 30k miles, turbos have 50k miles on them but do not blow smoke at all and pull hard. All silicon vaccum lined sequential setup. I had the motor comp tested at 55k miles when I bought it, nearly 9.0 on both faces, have the numbers. I can crank it outside the car with a battery on the starter and show you the pulses on a normal tester necessary.

I HAVE had it hydrocarbon tested, I have the documentation somewhere around here.

 

smic and bov w/ ducting $300! , downpipe $250!

 

Prices dropped!

Downpipe 100

Smic and bov 200
Duct 65

 

can you post some pics of the motor please

 

Would u sell just the short block ..as I already have a single turbo set up ..I just need a motor to drop in my fd and drive till I'm done rebuilding my race ported block .. if so please let me know .. thank you for your time .. and I'm also a member on rx7club ..