13bre intake manifold to 13brew, porting advice needed
03-30-2014 | 09:06 PM
#1
Thread Starter
Junior Member
Joined: Jan 2012
Posts: 2
13bre intake manifold to 13brew, porting advice needed
i am building at customers request a 13brew and the intake (LIM & UIM) will be 13bre.
i know this has been done before and did some searching but didn't score.
the bre intake gasket has a lower floor to the FD port by quite a margin.
is there enough meat on the FD floor to match the gasket?
what is the proper way to do the job... this will be a 500+ hp build.
thanks,
Howard
i know this has been done before and did some searching but didn't score.
the bre intake gasket has a lower floor to the FD port by quite a margin.
is there enough meat on the FD floor to match the gasket?
what is the proper way to do the job... this will be a 500+ hp build.
thanks,
Howard
04-13-2014 | 10:35 AM
#2
Senior Member
Joined: Jan 2002
Posts: 1,915
From: NJ USA
Re: 13bre intake manifold to 13brew, porting advice needed
i am building at customers request a 13brew and the intake (LIM & UIM) will be 13bre.
i know this has been done before and did some searching but didn't score.
the bre intake gasket has a lower floor to the FD port by quite a margin.
is there enough meat on the FD floor to match the gasket?
what is the proper way to do the job... this will be a 500+ hp build.
thanks,
Howard
i know this has been done before and did some searching but didn't score.
the bre intake gasket has a lower floor to the FD port by quite a margin.
is there enough meat on the FD floor to match the gasket?
what is the proper way to do the job... this will be a 500+ hp build.
thanks,
Howard
Thread
Thread Starter
Forum
Replies
Last Post
howard coleman
Rotary Engine Building and Porting FAQ Section
0
03-30-2014 09:02 PM
rmphillip
Rotary Engine Building, Porting & Swaps
11
05-08-2003 05:06 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)