New Member Introduction
#2
Re: New Member Introduction
Hello everyone,
My name is Ryan, I'm form Halstead, Kansas. I just bought an 84 RX-7 from a co-worker of mine. The car has been sitting for around ten years. It was parked after a brake caliper seized up. Me an a friend picked it up Monday night. I'm not sure where to even start right now. I figure I'll start with basic tune up and maintenance and see if we can get her to start. I now it needs brakes at all four corners, and probably a clutch. Its definitely not the prettiest car, but it has potential. I'm here because I've never owned a rotary car. In fact this is the first vehicle I've owned that wasn't American made. I hope to get to meet all of you, and draw on the knowledge you all have.
Thanks in advance!
My name is Ryan, I'm form Halstead, Kansas. I just bought an 84 RX-7 from a co-worker of mine. The car has been sitting for around ten years. It was parked after a brake caliper seized up. Me an a friend picked it up Monday night. I'm not sure where to even start right now. I figure I'll start with basic tune up and maintenance and see if we can get her to start. I now it needs brakes at all four corners, and probably a clutch. Its definitely not the prettiest car, but it has potential. I'm here because I've never owned a rotary car. In fact this is the first vehicle I've owned that wasn't American made. I hope to get to meet all of you, and draw on the knowledge you all have.
Thanks in advance!
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)