I have a 1990 N/A 5spd RX7



It's not flooded!



I changed the clutch master cylinder out 2 days ago. The new master is working just fine, but the car has not run since.



The battery is fully charged.



I connected 12v to the ignition on the starter and it turned my car over just fine.



All of the accesories work just fine on the car, including the fuel pump, when the ignition is switched to on.



The switch on the clutch pedal is fine. I've even bypassed it just to check and there was no change.

When I turn the switch to start, there is no clicking from the starter, the lights do not dim, and voltage does no drop.



My guess is I've accidentally bumped something or something shorted out when I changed the master. I've never had any problem starting the car before this in 14 months of ownership.



Any help from more experienced members would be greatly appreciated!

 

It's still not working. I'm going to post twice more so I can actually put my question in the correct area on the forum.

 

Hello again, hopefully someone will respond in the 2nd gen forum.

 

pop your hood open on drivers side ata the fusebox... try to wiggie one of the two black wires, have key turned to "on" postion while you wigge the wires i'm telling you to try, and then go and try to start it.. let me know and let us know if it worked.

 

good luck with that

 

Try replacing the plugs.

 

To insure "the starter itself is fine" take something and jump trigger the starter manually. Please make sure your car is out of gear... and on jackstands with your rear wheels properly blocked... Just because you get no clicks doesnt mean your starter is ok. Hopefully by now you have gotten it running or figured out the problem.