Ok I remember there being a thread about this somewhere. I looked

but no dice.



This is just for info. Some people were asking if it was recessed, but I said

it wasnt, and I would get a pic. Well here is the pic really late

 

DAMN! thats a big pic.... Sorry guys

 

i remember that thread too..... it was fd3boost that was askin.......... thats a pretty big hole

 

That's WAY to precise a hole for me to be cuttin... LOL

 

Yeah on the one end of the little light it has a plastic hook, and the

other is like a latch. You put it in at an angle going to the left(the smaller notch)

and snap it in on the right. Im surprised they never fall out, haha it seems

pretty cheeze.



I do like the look of the lights, but I have seen them in the US without too

either way it looks good IMO

 

My cut wasn't that precise but it works. stays in good and tight. Just make sure the ends are cut right. It was very very scary cutting into the fender of my FD. Once you start there is no going back. I like it though.

 

hmmmm........ no cutting for me ......hehe

 

Yea I'll pass on the cutting

I wuldnt do that unless I had the fenders for the lights.

Got pics of the hack job?

 

let me bust out my ghetto tool, dremal is the shiznit.

you don't have to make it as precise as stock. since the light can covers up the edge...

 

Just make sure you get some kind of anti-rust spray on the edges of that cut when you do it.

Better safe then sorry for what it will cost you for a can of Tremclad.

Keep that bare metal away from the elements.



Cheers

Shawn