Tech Edge Vs. Fjo
#1
I've heard that the Tech edge responds slower than FJO.
Any truth to that? Anyone have any other comparisons to make aside from the obvious price difference.
http://www.techedge.com.au/
http://www.widebando2.com/
Any truth to that? Anyone have any other comparisons to make aside from the obvious price difference.
http://www.techedge.com.au/
http://www.widebando2.com/
#5
You wont get a faster responce than a LM-1 from Innovate Motorsports !
Fastest (I have seen & used)
Most accurate (due to calibration method)
VERY REPEATABLE (se my testing results)
Does not rely on factory calibration chip in sensor ! (which means it will stay accurate)
You can read my review on the group buy section of this forum and in greater detail ont he other forum.
I have used many WB meters and this one is the one I like the best I know it was not mentioned in your thread but I though you might like to know of the other options around (Price is by far the best and based on the performance should be 5 times as much !)
Fastest (I have seen & used)
Most accurate (due to calibration method)
VERY REPEATABLE (se my testing results)
Does not rely on factory calibration chip in sensor ! (which means it will stay accurate)
You can read my review on the group buy section of this forum and in greater detail ont he other forum.
I have used many WB meters and this one is the one I like the best I know it was not mentioned in your thread but I though you might like to know of the other options around (Price is by far the best and based on the performance should be 5 times as much !)
#6
The tech edge does respond slow in their display. I've never had any problems once it's plugged into the Power FC though. I'm not familiar with the TechEdge software, since we use a 2 wire out to the datalogit and log with that instead of the techedge software.
Thread
Thread Starter
Forum
Replies
Last Post
Sophia Manning
Insert BS here
0
06-05-2012 03:47 PM
Sophia Manning
Canadian Forum
0
06-05-2012 03:47 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)