If anyone can help me, that would be great. I need a base map for my car in order for it to start and run ok so that I can go get it tuned.



Here are my mods:

BNR Race Ported Motor (large street port)

GT35/40

Blitz FMIC

756/1680 injectors

A1000 FP

HKS twin power

Full Exhaust

3 Bar Map sensor



I think that is all that matters as far as a base map is concerned.



I know for the 3Bar MAP sensor to go to Option 2 and set the scale to 41,800 and the offset to 0. But I need some sort of rich map with safe timing, so that I can drive my car for the break in period and get it set up for a dyno tuning in a few weeks.



If anyone has mods similar to these, I am willing to pay for a map.



Thanks,

Scott

 

as long as you keep the boost conservative you should be fine with the base map. I drove around for many months on the base map with mods similar to yours running 1.0-1.10 kg/cm2 boost without any problems. I have a TE WB with display and was always <10.5 at WOT and mostly 12s cruising with some 13s at light cruise-low knock 20s-30s. Again base maps fuel and timing. Be sure to select appr inj. sizes.