Well, I have finally decided to install my Haltech which I have had for over a month in my Turbo II. I have set of 1680s laying around and set of new 1000s laying around left over from a still born drag car project.



I believe 1000s are little too big for primaries for a street car. What does every recommend I pick up from Primary injectors for street ported 13BT? I have ball bearing T72 laying around I am going to try to run at first, if the lag gets to me too much time order a smaller turbo.

 

I've wired in 1000cc for primaries in a single FD...idles fine. Street driven.

 

Really? Driving them with E6K or E6X? If I can get a good idle I will run the 1000cc injectors, considering I have them and I would hate to take a loss on them selling them. I kinda wish I would have kept more FC parts than sold them. I took real beating on them, I never knew FC owners could be so cheap. It got so bad that decided to hold on to some of them. Like the 300M driveshaft shop axles I have laying around for the FC.

 

1000cc primaries on my FD single- No problems

 

1,000's are fine.

You might be able to get those 1600's to idle too.





-Ted

 

Thanks Ted, I wasn't sure if I was going to have any problem getting those 1000 to idle. I already have them, and they have never been used. It would have been a shame to take a loss on them, so I could buy smaller primaries.





So its going to be 1000cc Primaries and 1680cc secondaries.



I might have a few questions next week when I start wiring everything.





Thanks again for everyones info.