I need to find a copy or the wiring diagram of the Igntion module of the E11 the manual's pin out diagrams does not seem to cover this part and I dont have a copy. I would apreciate any info, or a copy of this particular diagram.



Thanks,



Luc

 

Hmm haye you tryed the haltech support group on egroups/yahoo groups?



Wish I need more about the E11 but don't.



PM mike (j9fd3s) he might know.

 

the diagrams are all up on the haltech website

 

Well I joined the haltech group but my admission is curently pending...

As far as this diagram is conserned, I did not find it in the download section of the haltech site. I already have the updated ECU Pinout diagram and the latest manual available (again from haltech website). referring to page 21 of the current manual:



"Included with your ignition module, should be a wiring diagram for your ignition module"



This is the diagram I do not have. i'm assuming the diagram isnt very big considering there are only 7 wires entering/exiting the module...

 

ah ok i'm not using the haltech ignition modules. hmm is it this one?

http://www.motec.com.au/drawings/m11.pdf

 

Thanks, that Is very close to what I am looking for (needs to run more than one coil though) and gives me a good idea what the wires are supposed to do.

 

i think they all use that bosch ignitor

 

Its all good I just got an email back from haltech support I was actually very suprised they were very quick to respond. Thanks for piching in j9fd3s its nice to know people are willing to help.



This is the piout in case someone needs it in the future



1-COIL NEGATIVE #1

2-ECU IGNITION OUTPUT #1

3-COIL NEGATIVE #3

4-CHASSIS GROUND

5-ECU IGNITION OUTPUT #3

6-COIL NEGATIVE #2

7-ECU IGNITION OUTPUT #2