my R100 is going in the shop this week for a face lift... just trying to make sure my funds are in line. here is an auction that may intrest some of you.

there is a statement in there about this *may* not fit with your current rail. i put this in there as a disclaimer so nobody starts crying. if it does not fit properly, it is a very easy fix. but there are so many styles of secondary rails out there, it is hard to say what works in combo w/ other *styles*



http://cgi.ebay.com/ebaymotors/ws/eBayISAP...5&category=6755

 

Would this fit a s5 t2?

 

actualy, i dont know... i will try it on a motor and let you know. i dont see why it wouldnt. they mount the same from my memory. its the placement of the secondaries that is diferent on a s5... no?

 

between and FD and FC yes, the secondaries placement is different, and sidefeed vs topfeed. I'm pretty sure that should fit my Fc, just want to make sure before I start bidding. And this fitment issue would only be on an FD, right? since of the location of the secondary rail on the fd.... What size fitting is this setup for 6-AN?

 

the fitment problem i have found is w/ a "bolt as a post style rail" but not with a piece of L or U channel as the post. i am aware of the top v.s. side feed, but picturing the center plate i cant remeber much of a diference of the placement of the bolts. i dont want to say yes if i am not sure. i am not going to mislead you. i am not like that. if you think it will fit, good luck in your bidding. but until i actualy try it on one, i stand by saying i am not possitive. i will try it on a spare TII motor i have sitting around. do you know if this would matter that it is a s4 TII motor? i dont think it would??

i have -8 on my car. the inside bore is tapped for 3/8NPT. yes you can get a -6 to 3/8 fitting. i believe they are like $4.00 form summit. if you are using -6 and dont have the fittings... i have a big box of fittings that i could help you out with.

 

If it fits on the s4 it should fit on my s5. I already have fittings, thxs for the offer. I also have a tap set so I would be set there too. Do you have access to more of these? I also need a secondary rails, as I have 1600cc inj, and I know that k2rd makes them, but i want to shop around for the best price on those.

 

i have plenty. i can make a secondary rail for you. send me a PM and i will give you contact info. i have just not gotten around to it yet. only *needed* rails for FD motors so far. i am going to have to make ones for TII motors as there is a rx3 w/ TII motor that is awaiting my lazy *** to install a e6k and some other goodies in it. i can always bang an extra one out.

 

bump

 

i got a primary rail from keith also. will let you know when it gets put in with my 1680cc primary injectors

 

damn jon, i didnt think you were going to put 160lbs in there. SHEEEESHHH. you may have to definatly refit the orings... yo may have to send that back to me and i will have to do a different bore or sink on the rail... i didnt realize you were going THAT big... email me if any problems. you know i will take care of it. did you get it yet? should have been there already.