3rd Generation Specific Talk about 3rd gen RX-7's here.

Engine sputters under load

Thread Tools
 
Search this Thread
 
Old 11-20-2010 | 09:39 PM
  #1  
DavidPorter's Avatar
Thread Starter
Junior Member
 
Joined: Nov 2010
Posts: 1
Default

So, I just did an entire rebuild. Things looked pretty good after startup, good oil pressure, seemed to be ok, and I let it run for a bit. However, then the problems started. These all may or may not be related.



1. I have error codes 12 and 18. This is the Throttle Position Sensor. However it is hooked up just as it was before! what exactly will throw this code?



2. The car runs like crap as soon as you hit boost. It will buck like crazy, doesn't have any power, and is worst at low RPM. Higher RPM (above 6k) it will run smoothly but doesn't have any power.



3. The idle is around 500 and the car will actually die some times. Is this related?



4. It may or may not be missing every once and a while. I am not sure about this.



5. A much less important issue, I unplugged the smaller connector from CPU2 as my car currently thinks it is stolen. If it helps, my Viper locking system doesn't work either. This is low on the priority list, but if anyone has dealt with this before so I don't have to trace everything I would appreciate the advice.



Thanks
Old 04-25-2011 | 09:24 PM
  #2  
JonathanMorales's Avatar
Junior Member
 
Joined: Apr 2011
Posts: 1
Default

Did you find out what the problem was? I'm having almost the same problem. My FD idles fine and driving is ok until it gets to 4000rpms under load if i dont step on it and drive nomral its fine....any idea?
Old 04-25-2011 | 11:47 PM
  #3  
thatpoorguy's Avatar
Senior Member
 
Joined: Nov 2009
Posts: 1,833
From: peru, IN
Default

It bogs or stumbles when you first hit the gas hard? Or does it only do that over 4k rpm's?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
RACING_INNOVATIONS
3rd Generation Specific
5
03-20-2009 02:13 AM
rotarycrew
2nd Generation Specific
3
09-07-2008 10:57 AM
jrsprjctrx7
2nd Generation Specific
2
06-29-2005 06:06 AM
zmarko
3rd Generation Specific
13
04-26-2005 11:08 PM
Benny
3rd Generation Specific
16
06-30-2003 04:26 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -5. The time now is 05:21 AM.