Hey Everybody.. Well after about 3 years of being parked in my driveway, I finally had the energy to try and start up my '88 Turbo II few weeks ago and voila! she still idles very smoothly; However, I noticed the brakes didn't work and that the fluid reservoir was bone dry. I later found out that my brake lines right underneath the driver side had been leaking fluid and worst is that the fuel line is also leaking gasoline right next to it. I haven't discovered anything else wet so I figured that's the only location leaking.

Now, my question is, Is there a place where I can order a prefabricated hard lines ready to be installed for my car? I'm sure I can do my own bending and flaring but I neither have the extra time nor the experience for such job especially when my life will be depending on it.. And plus, I'm too lazy hence the 3 yrs of being parked.! I decided to just go ahead and change the whole tubing from the Brake master cylinder (ABS unit removed and bypassed) to all four corners. Also, I plan on changing the whole fuel line as well from the tank to the engine bay... Any suggestions/comments are appreciated... Thanks guys!



Chad





My mods:



Basically stock except for some bolt-ons...

 

i would imagine you could just get the oem lines already bent from Ray @ Malloy Mazda 1-888-533-3400

 

Thanks for the reply.. You don't happen to know if they have a website, do you?