jetting weber dcoe 45 to a 6p 13b
#1
ok so ive searched this site and rx7club.com ive a got 83 rx7 with a 84 se motor only thing done to motor is i put a k&n filter ,header and 45 dcoe sidedraft i ve got the holley red top pump the car will start run alright untill u try to floor it and it just falls flat on its face i know i got 40mm chokes witch r to big and i cant tink of with the other jet sizes are any help would be greatfull
#2
i would think 40 venturies would be ok.
when you say falls on its face is it, lean? or rich?
do you have a wideband o2 sensor?
theres a cheap weber tuning book, you should be able to pick it up at borders/barnes and noble, it does a good job of explaining how the carb works
when you say falls on its face is it, lean? or rich?
do you have a wideband o2 sensor?
theres a cheap weber tuning book, you should be able to pick it up at borders/barnes and noble, it does a good job of explaining how the carb works
#4
you need to know your emulsion tube and other jets or noone can help you. I doubt tyou searched rx7club very well because there are countless 45 dcoe threads I have posted in where I have made recomendations on setups.
Thread
Thread Starter
Forum
Replies
Last Post
RotaryConcepts
RX-7 & RX-8 Parts For Sale & Wanted
1
12-14-2003 02:21 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)